The 3M Rust Fighter-I is built to help prevent corrosion of metal inner body panels and frame rails on automobiles.

Build

This rust fighter is built to stick to metal and not peel off.

It stays soft, flexible and self-heals if scratched or marred.

Can be applied directly to bare or primed metal.

Most common areas to apply this rust fighter is rocker panels, interior quarter panels, and door skins on any type of vehicle.

This product is also known as Cavity Wax!

Safety

If product gets into eyes or on skin, flush with lots of water. Seek medical attention if symptoms persist.

Keep away from heat, sparks, flames, and other ignition sources. Wear eye protection, mask, gloves, and cover any exposed skin. Use only in a well ventilated area.

VOC limit = 1.55g 03 per g product. This product is 0.85g 03 per g product.

How to Use

• Shake can vigorously
• Insert spray straw into tip
• Direct flow wherever needed
• Apply a thin layer over any areas needing protection
• Note that this product is NOT paintable, so apply accordingly

Clean-Up and Storage

Dispose of contents and container according to HAZMAT regulations.

Store in a well-ventilated area, away from sunlight, and below temperatures exceeding 50 °C.

Certifications, Standards, and Regulations

• Complies with the China "Measures on Environmental Management of New Chemical Substance"
• Complies with the Korea Chemical Control Act
• EINECS
• NICNAS
• RA 6969
• CEPA
• TSCA