The Cooper B-Line C-Clamp has a size range of 3/8"-16 thru to 3/4"-10 rod.

The clamp is made out of cast malleable steel with a hardened cup point set screw and jam nut.

B-Line recommends this clamp for hanging from steel beam where flange thickness does not exceed 3/4" (19.0mm). You may use this clamp on top or bottom flange of the beam. The beveled lip allows you to hang from top flange where clearance is limited.

This clamp may be installed with the set screw in the up or down position.

The offset construction gives you unlimited rod adjustment by allowing the rod to be threaded completely through the clamp.

The rear window permits inspection of thread engagement.

The clamp's finish is plain, but you can contact B-Line for alternative finishes and materials.

This clamp has the following approvals:

• Underwriters Laboratories Listed and Factory Mutual Engineering Approved for 3/8”-16 and 1/2”-13 rod sizes
• Conforms to Federal Specification WW-H-171E & A-A-1192A, Type 19 & 23 and Manufacturers Standardization Society ANSI/MSS SP-69 & SP-58, Type 19 & 23. 3/8"-16 is (cULus) Listed to support up to 4" (100mm) pipe with the set screw in the down position, up to 3" (75mm) pipe with the set screw in the up position
• 1/2"-13 is (cULus) Listed to support up to 8" (200mm) pipe with the set screw in the down position, up to 6" (150mm) pipe with the set screw in the up position